AP63800AA – AP63801AB – AP63802AC – AP63803AD – AP63804AE
1994 – 2002 7.3L Ford Powerstroke
H.E.U.I. Fuel system.
- Injector hold-down bolt: 120 inch-lbs.
- Rocker Arm Pedestal 20 lb-ft.
- Injector Spill Deflector 9 lb-ft.
*NOTE* Injector installation torque is critical to injector life and performance. Ensure the injector bore and injector seat are SPOTLESSLY CLEAN before installing. Debris/carbon can prevent injectors from sealing correctly which can create leaks or poor running complaints.
AP60900 – AP60901 – AP60800 – AP60801
2003 – 2007 6.0L Ford Powerstroke
H.E.U.I. Fuel system – SIEMENS injectors.
- Injector hold-down bolt: 26 lb-ft.
- Oil Rail ‘log’ manifold 8 lb-ft.
*NOTE* The most common install issue with these injectors is not having the injector FULLY seated and CORRECTLY torqued. If the copper tip sealing gasket does not properly ‘crush’, the injectors will start to leak in a couple of weeks time.
*PRO TIP* Once the injector is installed, we suggest to gently tap the top of the injector with a clean brass hammer and double-check the hold-down fasteners to ensure they are a minimum of 26 lb-ft. and can be as high as 30 lb-ft. without a problem.
*NOTE* Injector installation torque is critical to injector life and performance. Ensure the injector bore and injector seat are SPOTLESSLY CLEAN before installing. Debris/carbon can prevent injectors from sealing correctly which can create leaks or poor running complaints.
AP64900 – AP64800
2008 – 2010 6.4L Ford Powerstroke
SIEMENS fuel pump with PIEZO injectors
- Injector hold down bolt – initial torque- 18 inch-lbs.
- Then install the feed line ‘hand tight’.
- Then injector hold down final torque: 28 lb-ft.
- Then torque feed line nut: 106 inch-lbs.
- Then tighten feed line nuts +60 degrees to achieve final torque.
*NOTE* Injector installation torque is critical to injector life and performance. Ensure the injector bore and injector seat are SPOTLESSLY CLEAN before installing. Debris/carbon can prevent injectors from sealing correctly which can create leaks or poor running complaints.
0 986 435 415
2011-2014 6.7L Ford Powerstroke
BOSCH CP4 with PIEZO injectors
- Injector hold down bolt – initial torque – 22 lb-ft.
- Then tighten injector hold down bolt +90 degrees to achieve final torque.
*NOTE* Injector installation torque is critical to injector life and performance. Ensure the injector bore and injector seat are SPOTLESSLY CLEAN before installing. Debris/carbon can prevent injectors from sealing correctly which can create leaks or poor running complaints.
*NOTE* These injectors have TRIM (IQA) CODES that will need to be programmed into the ECM with a Scan Tool. Ensure the ECM has the correct trim codes programmed to get the longest life and best performance from the injectors. Contact us anytime if you require assistance.